Features |
N/A
Excellent Adhesion Over a Variety of Surfaces Fast dry Rust inhibitive |
Surface Preparation |
N/A Remove all dirt, scale, and grease. Commercial blast, sand, or wire brush for best results. |
Mixing and Thinning |
N/A Stir or shake well. Thin up to 15% with S 4, Odorless mineral Spirits or S 3, VMP&P Naphtha to spray. Ideal conventional spraying viscosity is 20-60" #2 Zahn depending on equipment. Spray unthinned when using airless equipment. Do not over-thin. |
Application |
N/A Brush, roll, spray. Thin as directed for conventional or H.V.L.P. spray. Airless and conventional are preferred spray methods. Apply between 50 and 95ºF with the relative humidity less than 80%. Do not expose to dew or rain within one hour after painting. Humidity can exceed 80% and dry times can be shortened if heat (no more than 250ºF) is applied after application. |
Dry Time |
N/A 20-30 minutes to touch. 8-10 hours hard |
Recoat Time |
N/A Before two hours or after 24 hours with an approved Warren enamel. |
Appearance |
N/A Flat reddish brown film. |
Composition |
N/A Magnesium silicate, red iron oxide, and zinc chromate. |
Vehicle |
N/A Long oil alkyd reduced with mineral spirits. |
% Solids by Weight |
N/A 62.82 |
% Solids by Volume |
N/A 41.0 |
Coverage |
N/A 438 square feet per gallon at 1.5 mils DFT (100% transfer and zero profile). |
V.O.C. |
N/A 3.20 lb/gal |
Cured Film Properties |
N/A Tough, durable film with excellent adhesion and corrosion resistance over steel and other substrates. |
Standard Packaging |
N/A Fifty-five gallon drums. Ones and fives are available by special order. |
