Features |
N/A
Excellent Adhesion Over a Variety of Surfaces Complete Coverage in One Coat Good Corrosion Resistance |
Surface Preparation |
N/A Remove all dirt, scale, and grease. Commercial blast, sand, or wire brush for best results. |
Mixing and Thinning |
N/A Stir or shake well. Thin up to 15% with S 46, Special Spraying Thinner or one of the many other specially formulated Warren reducers to spray. Ideal conventional spraying viscosity is 20-60" #2 Zahn depending on equipment. Thin sparingly when using airless equipment. Thin with Warren's S 40, High Flash Naphtha to brush or roll. Do not over-thin. |
Application |
N/A Brush, roll, spray. Thin as directed for conventional or H.V.L.P. spray. Airless and conventional are preferred spray methods. Apply between 50 and 95ºF with the relative humidity less than 80%. Do not expose to dew or rain within one hour after painting. Humidity can exceed 80% and dry times can be shortened if heat (no more than 250ºF) is applied after application. |
Dry Time |
N/A 10 minutes to touch. 30 minutes to handle. Eight hours hard |
Recoat Time |
N/A After 30 minutes with an approved Warren enamel. See your Warren representative for others. |
Appearance |
N/A Flat gray film. |
Composition |
N/A Magnesium silicate, titanium dioxide, calcium carbonate, and modified zinc phosphate. |
Vehicle |
N/A TOFA chain-stopped and soya medium alkyd resins modified with phenolic and reduced with xylene, VM&P naphtha, and toluene. |
% Solids by Weight |
N/A 59.8 |
% Solids by Volume |
N/A 38.6 |
Coverage |
N/A 413 square feet per gallon at 1.5 mils DFT (100% transfer and Zero profile). |
V.O.C. |
N/A 4.15 lb/gal |
Cured Film Properties |
N/A Tough, durable film with good adhesion and corrosion resistance over steel and other substrates. |
Standard Packaging |
N/A One gallon cans. Fives and drums are available by special order. |
