Features |
N/A
Excellent Adhesion to Properly Prepared Steel Quick Drying and Complete Coverage in One Coat Good Abrasion, Corrosion, and Chemical Resistance |
Surface Preparation |
N/A Remove all dirt, scale, grease, and moisture. Commercial blast, sand, or power brush for best results. Prime with a Warren Metalcoat primer for best results. |
Mixing and Thinning |
N/A Stir or shake well. Mix 8 to 1 with V13707, Urethane Hardener for best sun and chemical resistance properties. Pot life is one hour. Thin up to 15% with S 31, Xylene Blend or one of the many other specially formulated Warren reducers to spray. S 7, Acetone may be used to thin and keep VOC below 3.5 lb/gl. Ideal conventional spraying viscosity is 20-60" #2 Zahn depending on equipment. Do not thin when using airless equipment. Thin with Warren's S 40, High Flash Naphtha to brush or roll or in very hot conditions. Do not over-thin. |
Application |
N/A Brush, roll, spray. Thin as directed for conventional or H.V.L.P. spray. Airless and conventional are preferred spray methods. Apply between 50 and 95ºF with the relative humidity less than 80%. Do not expose to dew or rain within one hour after painting. Humidity can exceed 80% and dry times can be shortened if heat (no more than 250ºF) is applied after application. |
Dry Time |
N/A 30 minutes to touch. One hour to handle. Eight hours hard. |
Recoat Time |
N/A After four hours with an approved Warren enamel. See your Warren representative for others. |
Appearance |
N/A High gloss off-white film. |
Composition |
N/A Titanium dioxide. |
Vehicle |
N/A DCO/soya alkyd resin in an aromatic, acetate, ketone solvent blend. |
% Solids by Weight |
N/A 66.1 |
% Solids by Volume |
N/A 52.7 |
Coverage |
N/A 403 square feet per gallon (mixed) at 2.1 mils DFT (100% transfer and zero profile). |
V.O.C. |
N/A 3.02 lb/gal |
Cured Film Properties |
N/A Tough, durable film with good adhesion and corrosion resistance over steel and other substrates. |
