Surface Preparation |
N/A All surfaces must be sound, dry, clean and free of oil, grease, dirt and mildew. Scrape, sand, or pressure wash surfaces. Allow to wetted surfaces to dry 24 hours before painting. |
Mixing and Thinning |
N/A Stir or shake well. Thin up to 10% with S 3, VM&P Naphtha; or another recommended thinner to spray. Use as supplied or thin sparingly with S 4, Deodorized Thinner to brush or roll. Do not over-thin. |
Application |
N/A Brush, roll, spray. Thin as directed for conventional or H.V.L.P. spray. Apply between 50 and 95°F with the relative humidity less than 80%. Do not expose to dew or rain within eight hours after painting. |
Dry Time |
N/A 4-6 hours to touch. Eight hours to handle. Twenty-four hours hard. |
Recoat Time |
N/A Before four hours and after 24 hours. |
Appearance |
N/A High gloss deep red film. |
Pigmentation |
N/A Red Iron Oxide and calcium carbonate. |
Vehicle |
N/A Long oil alkyd and polysaccharide reduced with mineral spirits and extended with water. |
% Solids by Weight |
N/A 54.9 |
% Solids by Volume |
N/A 41.8 |
Coverage |
N/A 335 square feet per gallon at 2.0 mils DFT (100% transfer and zero profile). |
V.O.C. |
N/A 3.04 lb/gal (361 g/l) |
Cured Film Properties |
N/A Good adhesion to new and weathered wood. Good water resistance within twenty-four hours. Good resistance to aliphatic solvents and many oils within seven days. |
Standard Packaging |
N/A Five gallon pail. Gallons and drums are available by special order. |
