Call Us Toll-Free: 800.251.2625 | E-mail: AskMe@warrenpaint.com
All Categories > Industrial Coatings > High Heat Coatings > Item # 522  
    Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Item # 522, High Heat Grey High Temperature Enamel



Warren's High Heat Enamels are formulated to withstand exposure to elevated temperatures on interior and exterior metal structures. High Heat Enamels are supplied ready to spray and fully cure overnight. They are recommended for application to interior and exterior steel surfaces such as mufflers, smoke stacks, asphalt plants, and steam pipes that will be exposed to temperatures up to 400ºF. High Heat Enamels are also available in black and a high build version to best suit the your metal protection needs.




 Specifications   

Features

Heat Resistant
Weather and Corrosion Resistant
Ideal for Exterior Hot Metal Surfaces

Surface Preparation

Remove all dirt, scale, and grease. For best results, shotblast or obtain a commercial blast. Sanding or wire brush removal of any oxidation or scale is recommended if blasting is not feasible. Do not prime.

Mixing and Thinning

Stir or shake well. Thinning should not be necessary. If necessary, thin sparingly with S 46, Spraying Thinner; S 3, VM&P Naphtha; or another recommended thinner. Do not over-thin.

Application

Apply as supplied for airless spray. Thin as directed for conventional or H.V.L.P. spray. Apply between 50 and 95ºF with the relative humidity less than 80%. Do not expose to dew or rain within eight hours after painting. Do not allow the painted structure to exceed 140ºF for at least 24 hours after application. For best results apply two coats.

Dry Time

1-1/2 hours to touch. Eight hours to handle. Twenty-four hours hard.

Recoat Time

After twenty-four hours.

Appearance

Satin finish silver film.

Composition

Aluminum

Vehicle

Styrene-Butadiene alkyd resin reduced with mineral spirits and VM&P naphtha.

% Solids by Weight

41.3

% Solids by Volume

26.9

Coverage

431 square feet per gallon at 1.0 mil DFT (100% transfer and zero profile).

V.O.C.

5.15 lb/gal

Cured Film Properties

Good anticorrosive properties over steel and most metals. Good water and chemical resistance within twenty-four hours. Good resistance to aliphatic solvents and many oils within seven days.

Standard Packaging

One gallon cans (packaged four per case). Fives and drums are available by special order.


Copyright © 2011 Warren Paint & Color Co. , All Rights ReservedSite created by ThomasNet Web Solutions
Warren Paint & Color Co. - Evolving New Coating Solutions